How To Install Your Superior PVC /VInyl Fence
- Dec 12, 2017 -

Step 1- Measuring and Marking Off

The first step is to establish the measurements of the fence and its different sections. An equivalent area can now be measured off where the fence is going to be located using the stakes and string to create guides. The stakes for the corner posts should be a few inches past the post's final locations leaving the string to cross at the correct place. Set the posts at the same interval as the ends of the PVC fence sections. 

Measure for the gate and set the posts appropriately. 

Step 2- Digging the Holes

Dig holes for the terminal posts. The diameter of the dug holes should be 10 inches and the depth of the hole should be 1/3 of the posts length plus another 4 inches. 

Step 3- Setting the Terminal Posts

Mix the concrete according to the manufacturer’s directions. Working with one post at a time, pour the concrete into each hole and then lower the post into the cement. Level the post across the top with the regular level and check the vertical axis with the post level. Add more cement at this time in a manner where water will run away from the post. 

Tying string to the top of the inserted posts will provide you with a visual guide for inserting the line posts. These posts are set the same as the terminal posts. 

Step 4- Installing the Panels

Attach the rail brackets for the PVC fencing with screws and do the same with the rail hangers. 

The separate panels should comfortably slide into the brackets. Screw the panels into place on the hangers. 

Step 5- Finishing Up the Fence

E:\Intlspr\综合部\其他业务联系\索镁信息技术\PVC\新产品图\苏普瑞产品N\citywidefencettongueandgroovelattice_op_800x565.jpg

E:\Intlspr\综合部\其他业务联系\索镁信息技术\PVC\新产品图\苏普瑞产品N\552_看图王.jpg

E:\Intlspr\综合部\其他业务联系\索镁信息技术\PVC\新产品图\苏普瑞产品N\F1-1024x768.jpg